Irgendwie hakt`s gerade an was ganz banalen bei mir - kann ich nicht einfach sinnbildliche Zeilen benutzen, um per variable mehrere tabellen anzusprechen ?`


Code:
dim x as byte , y as byte
x=5

do
   restore dta(x)
   Read y
   print y
loop
end


Dta5:                                          
Data 0 , 62 , 81 , 73 , 69 , 62 , 0 , 0

Dta6:                                          
Data 0 , 62 , 81 , 55 , 23 , 62 , 0 , 0

- sagt mir dann immer nur "label not found" -

..."restore dta5" funktioniert einwandfrei....aus der Bascom-Hilfe werde ich diesbezüglich gerade nicht schlau...hat Jemand ein Tipp für mich ?