Hallo zusammen,
ich spiele gerade wieder mit den AVRs . Bei einer meiner Schaltungen hab ich einfach den Quarzaufbau des RN-Minicontrols [3] übernommen (2x22pF + 16MHz). Aber: Bei meinem projekt lief der AVR (Atmega168p) nicht an. Quarz [1] schwang nicht an. Während der Fehlersuche stiess ich auf das Appnote AVR042 [2] und im Kaptiel 4.1 auf Seite 12 über die Lastkondensatoren steht:

Where CL1 and CL2 refer to the external capacitors seen in Figure 4-1 and CL1S and CL2S are stray capacitances at the
XTAL pins of the AVR. Assuming symmetric layout, so that CL1 = CL2 = C and CL1S = CL2S = CS, then the external
capacitors can be determined by Equation 4-2 (CS can be estimated to be 5pF - 10pF):

C = 2 x CL - Cs
Der Quarz [1] hat eine Lastkapazität von 32pF. Also sollten doch auch im RN-Mini die beiden Lastkondensatoren bei
C = 2x 32pF - 8pF = 56 pF
liegen. Oder hab ich hier was falsch verstanden????

Gruß
Georg

[1] http://www.reichelt.de/Quarze/16-000...6391221a9526ba
[2] http://www.atmel.com/images/atmel-25...ote_avr042.pdf
[3] http://rn-wissen.de/wiki/index.php/RN-MiniControl